XC2288H_11 Datasheet, PDF (99/151 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2288H, XC2289H
XC2000 Family / High Line
Electrical Parameters
4.3.3 Power Consumption
The power consumed by the XC228xH depends on several factors such as supply
voltage, operating frequency, active circuits, and operating temperature. The power
consumption specified here consists of two components:
• The switching current I_S depends on the device activity
• The leakage current I_LK depends on the device temperature
To determine the actual power consumption, always both components, switching current
I_S and leakage current I_LK must be added:
I_DDP = I_S + I_LK.
Note: The power consumption values are not subject to production test. They are
verified by design/characterization.
To determine the total power consumption for dimensioning the external power
supply, also the pad driver currents must be considered.
The given power consumption parameters and their values refer to specific operating
conditions:
• Active mode:
Regular operation, i.e. peripherals are active, code execution out of Flash.
• Stopover mode:
Crystal oscillator and PLL stopped, Flash switched off, clock in domain DMP_1
stopped.
• Standby mode:
Voltage domain DMP_1 switched off completely, power supply control switched off.
DMP_M domain is supplied by ultra low power electronic voltage regulator
(ULPEVR). The alternate regulator EVR_M is switched off.
Note: The maximum values cover the complete specified operating range of all
manufactured devices.
The typical values refer to average devices under typical conditions, such as
nominal supply voltage, room temperature, application-oriented activity.
After a power reset, the decoupling capacitors for V_DDIM and V_DDI1 are charged with
the maximum possible current.
For additional information, please refer to Section 5.2, Thermal Considerations.
Note: Operating Conditions apply.
Data Sheet
99
V1.3, 2011-07