TC1765 Datasheet, PDF (66/88 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1765
Preliminary
Input/Output DC-Characteristics (cont’d)
V_SS = 0 V; T_A = -40 °C to +125 °C;
Parameter¹⁾
Symbol
Limit Values
Pin capacitance¹⁰⁾
(Digital I/O)
min.
C_IO CC –
max.
10
Unit Test Conditions
pF f = 1 MHz
T_A = 25 °C
Class C Pins (V_DDOSC = 2.30 to 2.75 V), see Page 68
1) _{All Class A pins of the TC1765 are equipped with Low-Noise output drivers, which significantly improve the}
device’s EMI performance. These Low-Noise drivers deliver their maximum current only until the respective
target output level is reached. After that the output current is reduced. This results in an increased impedance
of the driver, which attenuates electrical noise from the connected PCB tracks. The current, which is specified
in column “Test Conditions”, is delivered in any case.
2) _{This specification is not valid for outputs of GPIO lines, which are switched to open drain mode. In open drain}
mode the output will float and the voltage results from the external circuitry.
3) _{Output drivers in high current mode.}
4) _{Condition for output driver in dynamic current mode & low current mode – guaranteed by design}
characterization.
5) _{Input characteristics can be switched between TTL and CMOS via register Px_PICON except for dedicated}
pins which have CMOS input characteristics.
6) _{The maximum current can be drawn while the respective signal line remains inactive.}
7) _{The two pull-up/pull-down current test conditions for VOUT cover the curves as shown in Figure 20 and}
Figure 21. All pull-up/pull-down currents are given as absolute values.
8) _{The minimum current must be drawn in order to drive the respective signal line active.}
9) _{In case of Class B pins VDDx = VDD. In case of Class A pins VDDx = VDDP.}
10) _{Guaranteed by design characterization.}
11) _{The test condition for Class A pins is: VDDP = 4.5 to 5.25 V; for Class B pins: VDD = 2.3 to 2.75 V;}
12) _{The max. peak-short-circuit current resp. max. peak-back-drive current is limited by max. 20 mA and the peak}
period equivalent of 10 mA constant-short-circuit current resp. 10 mA constant-back-drive current. The integral
of I_SCBDpeak over the peak period is thus limited to 10 mA (provided: I_SCBDpeak ≤ 20 mA).
13) _{To be defined for Class B pads.}
14) _{Short-circuit or back-drive conditions during operation occur if the voltage on the respective pin exceeds the}
specified operating range (i.e. V_SCBD > V_DDP + 0.5 V or V_SCBD < V_SS - 0.5 V) or a short circuit condition occurs
on the respective pin. The absolute sum of input I_SCBD and I_OV currents on all port pins must not exceed
100 mA at any time. The supply voltage (V_DDP and V_SS) must remain within the specified limits. Under short-
circuit conditions the corresponding pin is not ready for use. In case of Class B pins V_DDx = V_DD. In case of
Class A pins V_DDx = V_DDP.
Data Sheet
62
V1.2, 2002-12