English
Language : 

TC1765 Datasheet, PDF (56/88 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller
TC1765
Preliminary
Recommended Oscillator Circuits
The oscillator circuit, designed to work with both, an external crystal oscillator or an
external stable clock source, basically consists of an inverting amplifier with XTAL1 as
input and XTAL2 as output. When using a crystal, a proper external oscillator circuitry
must be used, connected to both pins, XTAL1 and XTAL2. The on-chip oscillator
frequency can be within the range of 4 MHz to 16 MHz. When using an external clock
signal it must be connected to XTAL1. XTAL2 is left open (unconnected). For direct drive
operation without PLL, the frequency of an external clock must not exceed 40 MHz.
Figure 17 shows the recommended external oscillator circuitries for both operating
modes, external crystal mode and external input clock mode.
V DDOSC
V DDOSC
XTAL1
4-16
MHz
TC1765
Oscillator
XTAL2
C1
C2
V SSOSC
E x te rn a l
Clock Signal
XTAL1
TC1765
O s c illa to r
XTAL2
V SSOSC
MCB04996
Figure 17 Oscillator Circuitries
For the oscillator of the TC1765 the following external passive components are
recommended:
– Crystal: max. 16 MHz
– C1, C2: 10 pF
A block capacitor between VDDOSC and VSSOSC is recommended, too.
– C1, C2: 12 pF
Note: For crystal operation, it is strongly recommended to measure the negative
resistance in the final target system (layout) to determine the optimum parameters
for the oscillator operation. Please refer to the minimum and maximum values of
the negative resistance specified by the crystal supplier.
Data Sheet
52
V1.2, 2002-12