TLE9261-3QX Datasheet, PDF (62/186 Pages) Infineon Technologies AG – Dedicated Data Sheets are available for the different product variants

7.3
Electrical Characteristics
TLE9261-3QX
Voltage Regulator 2
Table 17 Electrical Characteristics
V_S = 5.5 V to 28 V; T_j = -40 °C to +150 °C; all voltages with respect to ground, positive current flowing into pin
(unless otherwise specified)
Parameter
Symbol
Values
Unit Note / Test Condition Number
Output Voltage including line
and Load regulation
(SBC Normal Mode)
V_CC2,out1
Min. Typ. Max.
4.9 5.0 5.1 V
1)_{SBC Normal Mode;}
10µA < I_VCC2 < 100mA
6.5V < V_S < 28V
P_7.3.1
Output Voltage including line V_CC2,out2 4.9 5.0 5.1 V
and Load regulation
(SBC Normal Mode)
1)_{SBC Normal Mode; P_7.3.16}
10µA < IVCC2 < 80mA
6V < VS < 28V
Output Voltage including line V_CC2,out3 4.9 5.0 5.1 V
and Load regulation
(SBC Normal Mode)
1)_{SBC Normal Mode;}
10µA < I_VCC2 < 40mA
P_7.3.2
Output Voltage including line
and Load regulation
(SBC Normal Mode)
V_CC2,out4
4.97 –
5.07 V
Output Voltage including line V_CC2,out5 4.9 5.05 5.2 V
and Load regulation
(SBC Stop/Sleep Mode)
2)_{SBC Normal Mode; P_7.3.14}
10µA < I_VCC2 < 5mA
8V < V_S < 18V
25°C < T_j < 125°C
Stop, Sleep Mode;
P_7.3.3
1mA < I_VCC2 < I_VCC2,Ipeak
Output Voltage including line V_CC2,out6 4.9
and Load regulation
(SBC Stop/Sleep Mode)
5.05 5.25 V
Stop, Sleep Mode;
10µA < I_VCC2 < 1mA
P_7.3.18
Output Drop
V_CC2,d1
–
VCC2 Active Peak Threshold
(Transition threshold between
low-power and high-power
mode regulator)
I_VCC2,Ipeak,r –
–
500 mV I_VCC2 = 30mA
V_S = 5V
1.9 3.5 mA ²⁾I_CC2 rising;
V_S = 13.5V
-40°C < T_j < 150°C
P_7.3.4
P_7.3.15
VCC2 Active Peak Threshold I_VCC2,Ipeak,f 0.5 1.3 –
(Transition threshold between
high-power and low-power
mode regulator)
mA ²⁾I_CC2 falling;
V_S = 13.5V
-40°C < T_j < 150°C
P_7.3.17
Over Current limitation
I_VCC2,lim
100 –
750²⁾ mA
current flowing out of
pin, V_CC2 = 0V
P_7.3.5
1) In SBC Stop Mode, the specified output voltage tolerance applies when I_VCC2 has exceeded the selected active peak
threshold (I_VCC2,Ipeak,r) but with increased current consumption.
2) Not subject to production test, specified by design.
Data Sheet
62
Rev. 1.1, 2014-09-26