XC161CJ_02 Datasheet, PDF (57/78 Pages) Infineon Technologies AG – 16-Bi t Single-Chip Microcontroller Preliminary

XC161
Derivatives
Preliminary
Electrical Parameters
Table 12 Current Limits for Port Output Drivers
Port Output Driver
Mode
Strong driver
Maximum Output Current
(I_OLmax, -I_OHmax)¹⁾
10 mA
Nominal Output Current
(I_OLnom, -I_OHnom)
2.5 mA
Medium driver
4.0 mA
1.0 mA
Weak driver
0.5 mA
0.1 mA
1) _{An output current above |IOXnom| may be drawn from up to three pins at the same time.}
For any group of 16 neighboring port output pins the total output current in each direction (ΣI_OL and Σ-I_OH)
must remain below 50 mA.
Power Consumption XC161
(Operating Conditions apply)
Parameter
Symbol Limit Values Unit Test Condition
Power supply current (active)
with all peripherals active
Idle mode supply current
with all peripherals active
Sleep and Power-down mode
supply current with RTC
disabled³⁾
I_DDI
I_IDX
I_PDO4)
min.
–
–
–
max.
30 +
mA
3.0 × f_CPU
25 +
mA
1.2 × f_CPU
20
µA
1)
f_CPU in [MHz]²⁾
f_CPU in [MHz]²⁾
V_DDI=V_DDImax5)
T_J ≤ 25 °C
1) _{During Flash programming or erase operations the supply current is increased by max. 5 mA.}
2) _{The supply current is a function of the operating frequency. This dependency is illustrated in Figure 10.}
These parameters are tested at V_DDImax and maximum CPU clock frequency with all outputs disconnected and
all inputs at V_IL or V_IH.
The V_DDP pins only draw leakage currents if no output is toggling. Otherwise, the respective charging current
must be delivered.
3) _{If the RTC remains active in Sleep or Power-down mode the supply current is increased by max. 100 µA.}
4) _{This parameter is determined mainly by the transistor leakage currents. This current heavily depends on the}
junction temperature (see Figure 11). The junction temperature T_J is the same as the ambient temperature T_A
if no current flows through the port output drivers. Otherwise, the resulting temperature difference must be
taken into account.
5) _{This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to}
0.1 V or at V_DDP - 0.1 V to V_DDP, all outputs (including pins configured as outputs) disconnected.
Data Sheet
53
V1.0, 2002-03