45111 Datasheet, PDF (16/184 Pages) List of Unclassifed Manufacturers – 14-DAY MONEY BACK GUARANTEE

2 Installing the SX-Key/Blitz Software
Figure 2 - First Time Running Window
This is to remind you that you should review some basic configuration settings first. Click the OK but-
ton, and press Ctrl-U to open the Configuration dialog shown to the right.
The only setting that is important for now is the selection of the serial port to which you have connected
the SX-Key/Blitz.
Figure 3 - Configure Window
The configuration dialog allows you to select COM1, COM2, COM3, or COM4.
Click the radio button in the “Serial Port” section that matches your installation.
Make sure that the remaining options are set to the defaults as shown here, and then click “Okay” to
close the configuration dialog window.
You may keep the SX-Key Editor active because you will need it to perform the next steps below.
Page 16 • SX-Key/Blitz Development System Manual 2.0 • Parallax, Inc.