EP3C10U256C6N Datasheet, PDF (74/274 Pages) Altera Corporation – Cyclone III Device Family Overview

5–14
Chapter 5: Clock Networks and PLLs in the Cyclone III Device Family
Clock Feedback Modes
Figure 5–10 shows a waveform example of the phase relationship of the PLL clocks in
this mode.
Figure 5–10. Phase Relationship Between PLL Clocks in Normal Mode
Phase Aligned
PLL Reference
Clock at the Input pin
PLL Clock at the
Register Clock Port
External PLL Clock
Outputs (1)
Note to Figure 5–10:
(1) The external clock output can lead or lag the PLL internal clock signals.
Zero Delay Buffer Mode
In zero delay buffer (ZDB) mode, the external clock output pin is phase-aligned with
the clock input pin for zero delay through the device. When using this mode, use the
same I/O standard on the input clock and output clocks to guarantee clock alignment
at the input and output pins.
Figure 5–11 shows an example waveform of the phase relationship of the PLL clocks
in ZDB mode.
Figure 5–11. Phase Relationship Between PLL Clocks in ZDB Mode
Phase Aligned
PLL Reference Clock
at the Input Pin
PLL Clock
at the Register Clock Port
External PLL Clock Output
at the Output Pin
Cyclone III Device Handbook
Volume 1
July 2012 Altera Corporation