EVAL-ADPD105Z-GEN Datasheet, PDF (3/26 Pages) Analog Devices – Supports the detection of UART

EVAL-ADPD105Z-GEN User Guide
GETTING STARTED
INSTALLING THE ADPD103_ADPD105
OPENMARKET WAVETOOL
Download the ADPD103_ADPD105 OpenMarket WaveTool
software package from the EVAL-ADPD105Z-GEN product
page. Unzip the folder and run the ADPD103_ADPD105_
OpenMarket_WaveTool_Setup.exe file found in the
WaveTool_x_x_x folder. Follow the prompts, beginning with
Figure 2, for software installation.
UG-1021
RUNNING THE ADPD103_ADPD105 OPENMARKET
WAVETOOL
To start the ADPD103_ADPD105 OpenMarket WaveTool
application, navigate to the ADPD103_ADPD105 OpenMarket
WaveTool from the Start menu and click
ADPD103_ADPD105_Tool (see Figure 4).
Figure 4. Navigate to ADPD103_ADPD105_Tool from the Start Menu
At startup, the application automatically checks whether the
installed ADPD103_ADPD105 OpenMarket WaveTool version
is up to date. If there is a newer version available, the user is
prompted to download the newest version, shown in Figure 5.
Figure 2. ADPD103_ADPD105 OpenMarket WaveTool Setup Window
CHECKING THE USB SERIAL CONNECTION IN
WINDOWS 7
Connect the USB cable to the EVAL-ADPD105Z-GEN
evaluation board. Ensure the COM port driver is installed
correctly. To verify proper installation, go to Control Panel >
All Control Panel Items > System > Device Manager, as
shown in Figure 3. In this case, the proper COM port selection
is USB Serial Port (COM16).
The EVAL-ADPD105Z-GEN evaluation board uses an FT232
USB UART IC. If the USB driver installation does not install
properly, refer to the corresponding FTDI Driver Installation
guide to the operating system in use, found on the FTDI website.
Figure 5. Automatic Version Update Prompt
Figure 3. USB Serial Port in Windows® 7
Rev. 0 | Page 3 of 26