EVAL-ADPD105Z-GEN Datasheet, PDF (19/26 Pages) Analog Devices – Supports the detection of UART

EVAL-ADPD105Z-GEN User Guide
RAW DATA FORMAT
Before using the UDP transfer tool, ensure the
ADPD103_ADPD105 OpenMarket WaveTool is opened and
running with the UDP transfer enabled. See Figure 60 for an
example of stored sample raw data.
UG-1021
The sample data transmits in the form of ASCII bytes in
hexadecimal characters. The sample data format is
F0136CFC0000000FE90000105000000EA000000FCC.
The hexadecimal data is formatted with the following
characteristics:
• The first two characters (F0) represent sync.
• Next two characters (13) represent size.
• Next two characters (6C) represent the sequence number.
• Next four characters (FC00) represent the time stamp.
• The remaining characters represent the hexadecimal
channel raw data and its count (based on the slot modes of
the ADPD103_ADPD105 OpenMarket WaveTool).
Figure 60. Sample Data
Table 1. UDP Data Count for Various Modes
Slot Mode
Data Format
Slot A Sum, 16 bits
00000FE9
Slot B Sum, 16 bits
Slot A Sum, 32 bits
Slot B Sum, 32 bits
Slot A Dig Int, 16 bits
Slot B Dig Int, 16 bits
Slot AB Sum, 32 bits
00000FE9 00001050
Slot A Dig Int, 32 bits
Slot B Dig Int, 32 bits
Slot A, 16 bits
00000FE9 00001050 00000EA0 00000FCC
Slot B, 16 bits
Slot A, 32 bits
Slot B, 32 bits
Slot AB, 16 bits
00000F7E 0000105C 00000EA8 00000FCC 00000FE9 00001064 00000EAD 00000FCE
Data Count
1
2
4
8
Rev. 0 | Page 19 of 26