EVAL-ADPD105Z-GEN Datasheet, PDF (15/26 Pages) Analog Devices – Supports the detection of UART

EVAL-ADPD105Z-GEN User Guide
TOOLS DROP-DOWN MENU OPTIONS
OPTIONS
The Options selection from the Tools drop-down menu shows
the general board settings as well as the UDP configuration.
General
The General tab contains information about the device, the
platform, and the firmware version.
UG-1021
Figure 43. Auto Update Option
CHECK FOR UPDATES
Use the Tools > Check For Updates function to manually check
for the availability of a new software update (seeFigure 44).
Figure 41. General Tab in Options Dialog Box
UDP Configuration
The UDP Configuration tab allows the user to configure the
port numbers for UDP communication. The UDP transfer tool
sends the raw data to the client via the specified port numbers.
The IP address field must display the IP address the UDP
transfer tool is running.
Use the Raw Data Transfer Port field to assign the port
number for sending raw data from ADPD103_ADPD105
OpenMarket WaveTool to the UDP transfer tool (see Figure 42).
Figure 44. Check For Updates Option
FIRMWARE UPDATE
Use the Tools > Firmware Update function to start the
firmware update process (see Figure 45).
Figure 45. Firmware Update Option
Note the ADPD103_ADPD105 OpenMarket WaveTool must be
connected with the evaluation board to perform the firmware
update; otherwise, the ADPD103_ADPD105 OpenMarket
WaveTool shows a disconnect message (see Figure 46).
Figure 42. UDP Configuration Tab in Options Dialog Box
AUTOMATIC UPDATE
The Tools > Auto Update function enables/disables the
automatic software update functionality at the time of tool start
(see Figure 43). When Auto Update is enabled, it checks for the
availability of a new ADPD103_ADPD105 OpenMarket
WaveTool update and prompts the user to update the tool with
the latest version.
Rev. 0 | Page 15 of 26
Figure 46. Connection Status for Firmware Update