EVAL-ADPD105Z-GEN Datasheet, PDF (18/26 Pages) Analog Devices – Supports the detection of UART

UG-1021
UDP TRANSFER TOOL
This section explains the raw data reception and data format for
various modes from the UDP transfer tool over UDP.
UDP TRANSFER TOOL SETUP
To setup the the UDP transfer tool, follow these steps:
1. Open the ADPD103_ADPD105 OpenMarket WaveTool
and go to Tools > Options > UDP Configuration. Enter
the IP address of the remote PC where the UDP transfer
tool is running.
EVAL-ADPD105Z-GEN User Guide
5. Enter a file name to save the raw data from the
ADPD103_ADPD105 OpenMarket WaveTool and press
enter (see Figure 57).
Figure 53. UDP Configuration Tab
2. Connect the hardware (File > Connect > Auto Connect or
File > Connect > Select Port) using the UART bridge on
the host PC.
Figure 57. Entering a File Name to Store Data
6. The received packet count is continuously displayed in the
ADPD103_ADPD105 OpenMarket WaveTool tool and the
raw data is stored in the file (see Figure 58).
Figure 54. Selecting Auto Connect
3. Open Graph View and check the UDP Transfer box in the
Time View tab.
Figure 58. Receiving Raw Data
7. Press the ESC key to stop receiving the data and close the
current file (see Figure 59).
Figure 55. Enable UDP Transfer
4. Click the Start button (see Figure 33) to send the raw data
through the UDP.
To save the raw data being transferred via the UDP to a data
file, open the receiver tool (UDPTransferTool.exe) and enter
the IP address of the system (see Figure 56).
Figure 59. Closing the File
Figure 56. UDP Receiver Tool
Rev. 0 | Page 18 of 26