EVAL-ADPD105Z-GEN Datasheet, PDF (11/26 Pages) Analog Devices – Supports the detection of UART

EVAL-ADPD105Z-GEN User Guide
Figure 20. Config File in Use Pane
A configuration file uses the following format:
Address Data #(comment optional)
The address is an 8-bit address and the data must be in 16-bit
format, as follows:
14 0555 #setup input PD configuration
15 0220 #number of averages = 4
18 1F80 #slot A channel 1 ADC offset
19 1F80 #slot A channel 2 ADC offset
APPLY CONFIGURATION
A previously loaded configuration remains in the memory of
the ADPD103_ADPD105 OpenMarket WaveTool software until
overwritten by a new configuration file using File > Load Cfg,
shown in Figure 18. Therefore, to return to a previously loaded
configuration quickly, it is not necessary to reload the
configuration. Instead, select File > Apply Config.
UG-1021
DUMP REGISTERS
With the ADPD103_ADPD105 OpenMarket WaveTool
software, the user can dump all the registers to a single file by
selecting File > Register Dump, shown in Figure 22. A file
dialog box opens, prompting the user to save the file to a
specific location with a specific name. Register contents are
then dumped to the specified file.
Figure 22. Dumping Registers
The following is an example of a register dump:
PD_SELECT (14) 0555
INT_AVG_MODE (15) 0220
CH1_OFFSET_A (18) 1F80
CH2_OFFSET_A (19) 1F80
The register is listed by name and the address is listed in the
corresponding hexadecimal value.
Figure 21. Apply Configuration
Rev. 0 | Page 11 of 26