EVAL-ADPD105Z-GEN Datasheet, PDF (16/26 Pages) Analog Devices – Supports the detection of UART

UG-1021
When Firmware Update is selected, the CM3WSD firmware
flashing tool opens. To flash the firmware, the user must ensure
that the correct path and file name are selected in the
CM3WSD dialog box, shown in Figure 47.
EVAL-ADPD105Z-GEN User Guide
SEND REPORT
If the software update failed for ten times continuously, the
OpenMarket WaveTool opens the dialog box shown in Figure 49.
Figure 49. Update! Dialog Box
When the user clicks Yes, the Email Request dialog box appears
(see Figure 50).
Figure 47. Firmware Flashing Tool
With the correct path name and file name entered in the File to
download field and the correct USB serial port selected from
the Serial Port drop-down menu, click Start. The user is
prompted to pulse the reset button while holding down the
download button on the evaluation board (circled in Figure 48).
The firmware download starts when this step is completed.
Figure 50. Email Request Dialog Box
Enter the user name in the Enter Your Name field and email ID
(this is the email address used when registering to receive the
software package) in the Enter Your Email ID field. After entering
a user name and email ID, click Send to initiate the report to
Analog Devices, Inc.
Figure 48. Serial Download and Reset Buttons to Flash Firmware
When the firmware download completes, click the Reset button
in the CM3WSD dialog box and click the Exit button. The user
can now return to the ADPD103_ADPD105 OpenMarket
WaveTool and reconnect the device via File > Connect to
commence testing with the updated firmware.
Rev. 0 | Page 16 of 26