W29GL256SH9T-TR Datasheet, PDF (65/88 Pages) Winbond – 256M-BIT 3.0-VOLT PARALLEL FLASH MEMORY WITH PAGE MODE

W29GL256S
9.3 DC Characteristics
Table 9-3 DC Characteristics
Description
Input Load Current
Output Leakage Current
VCC Active Read Current
VCC Intra-Page Read
Current
VCC Active Erase/Program
Current^1,2
VCC Standby Current
VCC Reset Current^2,6
Automatic Sleep Mode³
VCC Current during power
up²
Input LOW Voltage⁴
Input HIGH Voltage⁴
Output LOW Voltage^4,7
Output HIGH Voltage⁴
LOW VCC Power on Reset
Voltage²
Notes:
Param
Test Conditions
Min Type² Max Unit
ILI
VIN=VSS to VCC, VCC=VCC
max
+0.02 ±1.0 μA
ILO
VOUT=VSS to VCC,
VCC=VCC max
+0.02 ±1.0 μA
#CE=VIL, #OE=VIH, Address
ICC1 switching@ 5 MHz, VCC=VCC
max
55
60 mA
#CE= VIL, #OE= VIH, Address
ICC2 switching@ 33 MHz,
VCC=VCC max
9
25 mA
ICC3
#CE= VIL, #OE= VIH,
VCC=VCC max
45 100 mA
#CE, #RESET, #OE= VIH,
ICC4 VIH=EVIO VIL =VSS,
VCC=VCC max
70 100 μA
ICC5
#CE= VIH, #RESET= VIL,
VCC=VCC max
70 100 uA
ICC6
VIH =EVIO, VIL =VSS ,
VCC=VCC max, tACC + 30 ns
3
6 mA
ICC7
#RESET=EVIO, #CE=EVIO,
#OE=EVIO, VCC=VCC max,
53
80 mA
VIL
-0.5
0.3xEVIO V
VIH
0.7xEVIO
EVIO+0.4 V
VOL
IOL=100μA for DQ15-DQ0;
IOL=2mA for RY/#BY
0.15xEVIO V
VOH IOH=100μA
0.85xEVIO
V
VRST
0.8
V
1. ICC active, if there is an internal Algorithm in progress.
2. Not 100% tested.
3. When addresses remain stable for the specified period of time, Automatic sleep mode will enter the lower power
mode.
4. EVIO = 1.65V to VCC or 2.7V to VCC.
5. VCC = 3V and EVIO = 3V or 1.8V. When EVIO is at 1.8V, I/O pins cannot operate at >1.8V.
6. If an internal operation is in progress at the beginning of a reset, the current consumption will remain at the internal
operation specification until the internal operation is terminated by the reset. If no internal operation is in progress
when reset has begun or following the termination of an internal operation, ICC7 will draw current during what’s left
Publication Release Date: Jul 02, 2014
Revision C
65