W948D6FBHX5E-TR Datasheet, PDF (55/60 Pages) Winbond – 256Mb Mobile LPDDR

W948D6FB / W948D2FB
8.5.2 Output Slew Rate Characteristics
256Mb Mobile LPDDR
PARAMETER
MIN MAX UNIT NOTES
Pull-up and Pull-Down Slew Rate for Full Strength Driver
0.7
2.5 V/ns 1,2
Pull-up and Pull-Down Slew Rate for Three-Quarter Strength Driver
0.5
1.75 V/ns 1,2
Pull-up and Pull-Down Slew Rate for Half Strength Driver
0.3
1.0 V/ns 1,2
Output Slew rate Matching ratio (Pull-up to Pull-down)
0.7
1.4
-
3
Notes:
1. Measured with a test load of 20 pF connected to VSSQ.
2. Output slew rate for rising edge is measured between VILD(DC) to VIHD(AC) and for falling edge between VIHD(DC) to VILD(AC).
3. The ratio of pull-up slew rate to pull-down slew rate is specified for the same temperature and voltage, over the entire temperature and
voltage range. For a given output, it represents the maximum difference between pull-up and pull-down drivers due to process variation.
8.5.3 AC Overshoot/Undershoot Specification
PARAMETER
Maximum peak amplitude allowed for overshoot
Maximum peak amplitude allowed for undershoot
The area between overshoot signal and VDD must be less than or equal to
The area between undershoot signal and GND must be less than or equal to
8.5.4 AC Overshoot and Undershoot Definition
SPECIFICATION
0.5 V
0.5 V
3 V-ns
3 V-ns
Overshoot Area
2.5
2.0
VDD
1.5
1.0
Max Amplitude = 0.5V
0.5
Max Area = 3V-ns
0
VSS
-0.5
Time
(ns)
Undershoot Area
- 55 -
Publication Release Date : Oct, 15, 2012
Revision : A01-004