W948D6FBHX5E-TR Datasheet, PDF (26/60 Pages) Winbond – 256Mb Mobile LPDDR

W948D6FB / W948D2FB
7.3.2 Mode Register Set Command Timing
256Mb Mobile LPDDR
CK
CK
Command MRS
Address Code
NOP
tMRD
Valid
Valid
: Don't Care
NOTE:Code=Mode Register / Extended Mode Register selection
(BA0,BA1)and op-code (A0-An)
7.4. Active
Before any READ or WRITE commands can be issued to a bank in the LPDDR SDRAM, a row in that bank must be
opened. This is accomplished by the ACTIVE command: BA0 and BA1 select the bank, and the address inputs
select the row to be activated. More than one bank can be active at any time.
Once a row is open, a READ or WRITE command could be issued to that row, subject to the tRCD specification.
A subsequent ACTIVE command to another row in the same bank can only be issued after the previous row has
been closed. The minimum time interval between two successive ACTIVE commands on the same bank is defined
by tRC.
7.4.1 Active Command
CK
CK
CKE
(High)
CS
RAS
CAS
WE
A0-An
RA
BA0,BA1
BA
= Don't Care
BA=BANK Address, RA=Row
Address
- 26 -
Publication Release Date : Oct, 15, 2012
Revision : A01-004