LM3S1968 Datasheet, PDF (551/709 Pages) List of Unclassifed Manufacturers – Microcontroller

Stellaris^® LM3S1968 Microcontroller
15.1
Block Diagram
Figure 15-1. Analog Comparator Module Block Diagram
C2-
-ve input _{Comparator 2}
C2+
+ve input
output
<none>
+ve input (alternate)
ACCTL2
trigger
ACSTAT2
interrupt
reference input
trigger
C1-
-ve input _{Comparator 1}
C1+
+ve input
output
<none>
+ve input (alternate)
ACCTL1
trigger
trigger
ACSTAT1
interrupt
reference input
C0-
-ve input _{Comparator 0}
C0+
+ve input
output
C0o
+ve input (alternate)
ACCTL0
trigger trigger
ACSTAT0
interrupt
reference input
internal
bus
Voltage
Ref
ACREFCTL
Interrupt Control
ACRIS
ACMIS
ACINTEN
interrupt
15.2
Signal Description
Table 15-1 on page 551 and Table 15-2 on page 552 list the external signals of the Analog Comparators
and describe the function of each. The Analog Comparator output signals are alternate functions
for some GPIO signals and default to be GPIO signals at reset. The column in the table below titled
"Pin Assignment" lists the possible GPIO pin placements for the Analog Comparator signals. The
AFSEL bit in the GPIO Alternate Function Select (GPIOAFSEL) register (page 309) should be set
to choose the Analog Comparator function. The positive and negative input signals are configured
by clearing the DEN bit in the GPIO Digital Enable (GPIODEN) register. For more information on
configuring GPIOs, see “General-Purpose Input/Outputs (GPIOs)” on page 286.
Table 15-1. Analog Comparators Signals (100LQFP)
Pin Name
Pin Number Pin Type Buffer Type^a Description
C0+
90
I
Analog Analog comparator 0 positive input.
C0-
92
I
Analog Analog comparator 0 negative input.
C0o
58
O
TTL
Analog comparator 0 output.
C1+
24
I
Analog Analog comparator 1 positive input.
C1-
91
I
Analog Analog comparator 1 negative input.
July 15, 2014
551
Texas Instruments-Production Data