LM3S1968 Datasheet, PDF (28/709 Pages) List of Unclassifed Manufacturers – Microcontroller

Revision History
Table 1. Revision History (continued)
Date
April 2009
Revision Description
5367 ■ Added JTAG/SWD clarification (see “Communication with JTAG/SWD” on page 165).
■ Added clarification that the PLL operates at 400 MHz, but is divided by two prior to the application
of the output divisor.
■ Added "GPIO Module DC Characteristics" table (see Table 21-4 on page 654).
■ Additional minor data sheet clarifications and corrections.
January 2009
4660
■ Corrected bit type for RELOAD bit field in SysTick Reload Value register; changed to R/W.
■ Clarification added as to what happens when the SSI in slave mode is required to transmit but there
is no data in the TX FIFO.
■ Additional minor data sheet clarifications and corrections.
November 2008
4283
■ Revised High-Level Block Diagram.
■ Additional minor data sheet clarifications and corrections were made.
October 2008
4149
■ Corrected values for DSOSCSRC bit field in Deep Sleep Clock Configuration (DSLPCLKCFG)
register.
■ The FMA value for the FMPRE3 register was incorrect in the Flash Resident Registers table in the
Internal Memory chapter. The correct value is 0x0000.0006.
■ Incorrect Comparator Operating Modes tables were removed from the Analog Comparators chapter.
August 2008
3447
■ Added note on clearing interrupts to Interrupts chapter.
■ Added Power Architecture diagram to System Control chapter.
■ Additional minor data sheet clarifications and corrections.
July 2008
3108 ■ Additional minor data sheet clarifications and corrections.
May 2008
2972
■ The 108-Ball BGA pin diagram and pin tables had an error. The following signals were erroneously
indicated as available and have now been changed to a No Connect (NC):
– Ball C1: Changed PE7 to NC
– Ball C2: Changed PE6 to NC
– Ball D2: Changed PE5 to NC
– Ball D1: Changed PE4 to NC
– Ball F1: Changed PD7 to NC
– Ball F2: Changed PD6 to NC
– Ball E2: Changed PD5 to NC
– Ball E1: Changed PD4 to NC
■ As noted in the PCN, the option to provide VDD25 power from external sources was removed. Use
the LDO output as the source of VDD25 input.
■ Additional minor data sheet clarifications and corrections.
28
July 15, 2014
Texas Instruments-Production Data