DS125BR820 Datasheet, PDF (35/62 Pages) Texas Instruments – Low-Power 12.5 Gbps 8-Channel Linear Repeater

www.ti.com
DS125BR820
SNLS491B – JULY 2014 – REVISED FEBRUARY 2015
Address
Register
Name
0x2F
CH4 - CHA_0
SD_TH
0x30-
0x31
Reserved
0x32
CH5 - CHA_1
RXDET
0x33
CH5 - CHA_1
EQ
0x34
CH5 - CHA_1
VOD
Table 9. SMBus Slave Mode Register Map (continued)
Bit
Field
Type Default
EEPROM
Reg Bit
Description
7
Reserved
Yes Set bit to 0
6:4 Reserved
Set bits to 0
Signal Detect
3:2 Status Assert
Threshold
R/W 0x00
Status Assert threshold (1010 pattern 12 Gbps)
00'b = 50 mVp-p (default)
01'b = 40 mVp-p
Yes 10'b = 75 mVp-p
11'b = 58 mVp-p
Note: Override SD_TH pin and enable register control
via Reg 0x08[6]
Signal Detect
1:0
Status
De-assert
Threshold
Status De-assert threshold (1010 pattern 12 Gbps)
00'b = 37 mVp-p (default)
01'b = 22 mVp-p
Yes 10'b = 55 mVp-p
11'b = 45 mVp-p
Note: Override SD_TH pin and enable register control
via Reg 0x08[6]
7:0 Reserved R/W 0x00
Set bits to 0
7:6 Reserved
5:4 Reserved
R/W 0x00
3:2
RXDET
1:0 Reserved
7:0 EQ Control R/W 0x2F
7
Short Circuit
Protection
6:3 Reserved
R/W 0xAD
2:0 VOD Control
Set bits to 0
Yes Set bits to 0
00'b = Input is Hi-Z impedance
01'b = Auto Rx-Detect,
outputs test every 12 ms for 600 ms (50 times) then
stops; termination is Hi-Z until detection; once detected
input termination is 50 Ω
Yes
10'b = Auto Rx-Detect,
outputs test every 12 ms until detection occurs;
termination is Hi-Z until detection; once detected input
termination is 50 Ω
11'b = Input is 50 Ω
Note: Override RXDET pin and enable register control
via Reg 0x08[3]
Set bits to 0
Yes
INA_1 EQ Control - total of four levels.
See Table 4.
Yes
1 = Enable the short circuit protection
0 = Disable the short circuit protection
Yes Set bits to 0101'b
OUTA_1 VOD Control: VOD / VID Ratio
000'b = 0.57
001'b = 0.65
010'b = 0.71
Yes 011'b = 0.77
100'b = 0.83
101'b = 0.90 (default)
110'b = 1.00 (recommended)
111'b = 1.04
Copyright © 2014–2015, Texas Instruments Incorporated
Submit Documentation Feedback
35