LM3S828 Datasheet, PDF (416/526 Pages) Texas Instruments – ARM and Thumb are registered trademarks and Cortex is a trademark

Synchronous Serial Interface (SSI)
Bit/Field
1
0
Name
SSE
LBM
Type
R/W
R/W
Reset
0
Description
SSI Synchronous Serial Port Enable
Setting this bit enables SSI operation.
The SSE values are defined as follows:
Value Description
0 SSI operation disabled.
1 SSI operation enabled.
Note: This bit must be set to 0 before any control registers
are reprogrammed.
0
SSI Loopback Mode
Setting this bit enables Loopback Test mode.
The LBM values are defined as follows:
Value Description
0 Normal serial port operation enabled.
1 Output of the transmit serial shift register is connected internally
to the input of the receive serial shift register.
416
June 18, 2012
Texas Instruments-Production Data