LSM303AGR Datasheet, PDF (56/68 Pages) STMicroelectronics – ultra-low-power 3D accelerometer and 3D magnetometer

Register description
LSM303AGR
Table 69. INT2_SRC_A description
Interrupt active. Default value: 0
IA
(0: no interrupt has been generated; 1: one or more interrupts have been generated)
Z high. Default value: 0
ZH
(0: no interrupt, 1: Z high event has occurred)
Z low. Default value: 0
ZL
(0: no interrupt; 1: Z low event has occurred)
Y high. Default value: 0
YH
(0: no interrupt, 1: Y high event has occurred)
Y low. Default value: 0
YL
(0: no interrupt, 1: Y low event has occurred)
X high. Default value: 0
XH
(0: no interrupt, 1: X high event has occurred)
X low. Default value: 0
XL
(0: no interrupt, 1: X low event has occurred)
Interrupt 2 source register. Read-only register.
Reading at this address clears the INT2_SRC_A (35h) IA bit (and the interrupt signal on the
INT2 pin) and allows the refresh of data in the INT2_SRC_A (35h) register if the latched
option was chosen.
8.25
INT2_THS_A (36h)
Table 70. INT2_THS_A register
0
THS6
THS5
THS4
THS3
THS2
THS[6:0]
Table 71. INT2_THS_A description
Interrupt 2 threshold. Default value: 000 0000
1 LSb = 16 mg @ FS = 2 g
1 LSb = 32 mg @ FS = 4 g
1 LSb = 62 mg @ FS = 8 g
1 LSb = 186 mg @ FS = 16 g
THS1
THS0
8.26 INT2_DURATION_A (37h)
Table 72. INT2_DURATION_A register
0
D6
D5
D4
D3
D2
D1
D0
56/68
DocID027765 Rev 5