LAN91C96I Datasheet, PDF (42/110 Pages) SMSC Corporation – NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER

Non-PCI Single-Chip Full Duplex Ethernet Controller
The contents of MIR as well as the low byte of MCR are specified in 256* M bytes. The multiplier M is
determined by bits 11, 10 and 9 as follows:
DEVICE
FEAST
LAN91C90
FUTURE
FUTURE
FUTURE
BIT 11 BIT 10
0
1
0
0
0
1
1
0
1
0
BIT 9
0
1
1
0
1
M MAX MEMORY SIZE
2
256 (Note 7.1) 256
(Note 7.1) 2=128k
1
256 (Note 7.1) 256
(Note 7.1) 1=64k
4
256k
8
512k
16
1M
Note 7.1 Bits 11, 10 and 9 are read only bits used by the software driver to transparently run on different controllers
of the LAN9000 family.
I/O SPACE - BANK1
OFFSET
0
NAME
CONFIGURATION REGISTER
TYPE
READ/WRITE
SYMBOL
CR
The Configuration Register holds bits that define the device configuration and are not expected to change
during run-time. This register is part of the EEPROM saved setup in Local Bus mode only.
0
0
X
X
16BIT DIS LINK
function
0
1
of EN16*
pin
NO
WAIT
0
X
Reserved
1
0
FULL
STEP
0
INT
SEL1
0
SET
SQLCH
0
INT
SEL0
0
AUI
SELECT
0
X
NO WAIT - When set, does not request additional wait states. An exception to this are accesses to the
Data Register if not ready for a transfer. When clear, negates IOCHRDY for two to three 20MHz clocks on
any cycle to the LAN91C96I.
FULL STEP - This bit is used to select the signaling mode for the AUI port. When set the AUI port uses full
step signaling. Defaults low to half step signaling. This bit is only meaningful when AUI SELECT is high.
SET SQLCH - When set, the squelch level used for the 10BASE-T receive signal is 240mV. When clear
the receive squelch level is 400mV. Defaults low.
AUI SELECT - When set the AUI interface is used, when clear the 10BASE-T interface is used. Defaults
low.
16BIT - Used in conjunction with EN16* and IO is 8 to define the width of the system bus. If the EN16* pin
is low, this bit is forced high. Otherwise the bit defaults low and can be programmed by the host CPU.
DIS LINK - This bit is used to disable the 10BASE-T link test functions. When this bit is high the
LAN91C96I disables link test functions by not generating nor monitoring the network for link pulses. In this
mode the LAN91C96I will transmit packets regardless of the link test, the EPHSR LINK_OK bit will be set
and the LINK LED will stay on. When low the link test functions are enabled. If the link status indicates
FAIL, the EPHSR LINK_OK bit will be low, while transmit packets enqueued will be processed by the
LAN91C96I, transmit data will not be sent out to the cable.
Rev. 11/18/2004
Page 42
DATASHEET
SMSC DS – LAN91C96I