SI4464 Datasheet, PDF (7/56 Pages) Silicon Laboratories – HIGH-PERFORMANCE

Si4464/63/61/60
Table 3. Receiver AC Electrical Characteristics¹ (Continued)
Parameter
RX Sensitivity
RX Channel Bandwidth⁵
BER Variation vs Power
Level³
RSSI Resolution
Symbol
Test Condition
Min Typ Max Unit
P_{RX_0.5}
(BER < 0.1%)
(500 bps, GFSK, BT = 0.5,
f = 250Hz)³
— –126 — dBm
P_{RX_40}
(BER < 0.1%)
(40 kbps, GFSK, BT = 0.5,
f = 20 kHz)³
— –110 — dBm
P_{RX_100}
(BER < 0.1%)
(100 kbps, GFSK, BT = 0.5,
f = 50 kHz)¹
— –106 — dBm
P_{RX_125}
(BER < 0.1%)
(125 kbps, GFSK, BT = 0.5,
f = 62.5 kHz)³
— –105 — dBm
P_{RX_500}
(BER < 0.1%)
(500 kbps, GFSK, BT = 0.5,
f = 250 kHz)³
— –97 — dBm
P_{RX_9.6}
(PER 1%)
(9.6 kbps, 4GFSK, BT = 0.5,
f =  kHz)^3,4
— –110 — dBm
P_{RX_1M}
(PER 1%)
(1 Mbps, 4GFSK, BT = 0.5,
inner deviation = 83.3 kHz)^3,4
— –88 — dBm
P_{RX_OOK}
(BER < 0.1%, 4.8 kbps, 350 kHz BW,
OOK, PN15 data)³
—
–110
—
dBm
(BER < 0.1%, 40 kbps, 350 kHz BW, — –104 — dBm
OOK, PN15 data)³
(BER < 0.1%, 120 kbps, 350 kHz BW, — –99 — dBm
OOK, PN15 data)³
BW
1.1
—
850 kHz
P_{RX_RES}
Up to +5 dBm Input Level
—
0
0.1 ppm
RES_RSSI
— ±0.5 —
dB
Notes:
1. All specification guaranteed by production test unless otherwise noted. Production test conditions and max limits are
listed in the "Production Test Conditions" section in "1.1. Definition of Test Conditions" on page 14.
2. For applications that use the major bands covered by Si4463/61/60, customers should use those parts instead of
Si4464.
3. Guaranteed by qualification. BER is specified for the 450–470 MHz band. Qualification test conditions are listed in the
"Qualification Test Conditions" section in "1.1. Definition of Test Conditions" on page 14.
4. For PER tests, 48 preamble symbols, 4 byte sync word, 10 byte payload and CRC-32 was used. PER and BER tested
in the 450–470 MHz band.
5. Guaranteed by bench characterization.
Rev 1.2
7