H8S78 Datasheet, PDF (816/1208 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series

Section 15 Serial Communication Interface (SCI, IrDA)
15.7 Operation in Smart Card Interface Mode
The SCI supports an IC card (Smart Card) interface conforming to ISO/IEC 7816-3 (Identification
Card) as a serial communication interface extension function. Switching between the normal serial
communication interface and the Smart Card interface is carried out by means of a register setting.
15.7.1 Pin Connection Example
Figure 15.21 shows an example of connection with the Smart Card. In communication with an IC
card, since both transmission and reception are carried out on a single data transmission line, the
TxD pin and RxD pin should be connected with the LSI pin. The data transmission line should be
pulled up to the V_CC power supply with a resistor. If an IC card is not connected, and the TE and
RE bits are both set to 1, closed transmission/reception is possible, enabling self-diagnosis to be
carried out. When the clock generated on the SCI is used by an IC card, the SCK pin output is
input to the CLK pin of the IC card. This LSI port output is used as the reset signal.
TxD
RxD
SCK
Rx (port)
This LSI
Connected equipment
V_CC
Data line
Clock line
Reset line
I/O
CLK
RST
IC card
Figure 15.21 Schematic Diagram of Smart Card Interface Pin Connections
Rev.7.00 Mar. 18, 2009 page 748 of 1136
REJ09B0109-0700