M16C6C Datasheet, PDF (5/94 Pages) Renesas Technology Corp – RENESAS MCU

M16C/6C Group
1. Overview
Table 1.2
Item
Specifications (2/2)
Function
Timer A
Timers
Timer B
Three-phase motor control
timer functions
Real-time clock
Timer S (Input capture/output
compare)
Serial
Interface
UART0 to UART5
Multi-master I²C-bus Interface
USB Functions
A/D Converter
D/A Converter
CRC Calculator
Flash Memory
Debug Functions
Operation Frequency/Supply Voltage
Current Consumption
Operating Temperature
Package
Description
16-bit timer × 5
Timer mode, event counter mode, one-shot timer mode, pulse width
modulation (PWM) mode
Event counter two-phase pulse signal processing (two-phase encoder
input) × 3
Programmable output mode × 3
16-bit timer × 6
Timer mode, event counter mode, pulse period measurement mode,
pulse width measurement mode
• Three-phase inverter control (timer A1, timer A2, timer A4, timer B2)
• On-chip dead time timer
• Count: second, minute, hour, day of the week
• Input base timer: 16 bits X 1
• I/O: 8 channels
• Time measurement register, Waveform generation register: 16 bits X
8
Clock synchronous/asynchronous × 6 channels
I²C-bus, IEBus⁽¹⁾,
Special mode 2, SIM (UART2)
1 channel
• Full speed (12 Mbps, USB 2.0 compliant)
• Transfer type: Control IN/OUT, Bulk IN X 2, Bulk OUT X 2,
Interrupt IN X 2
• FIFO size: 584 bytes
• Setup 8 bytes
• Control IN 16 bytes
• Control OUT 16 bytes
• Interrupt IN 16 bytes: 2 channels
• Bulk IN 64 bytes X 2: 2 channels
• Bulk OUT 64 bytes X 2: 2 channels
10-bit resolution × 26 channels (2 circuits), including sample and hold
function
Conversion time: 1.72 μs
8-bit resolution × 2 circuits
CRC-CCITT (X¹⁶ + X¹² + X⁵ + 1), CRC-16 (X¹⁶ + X¹⁵ + X² + 1)
compliant
• Program/erase power supply voltage: 2.7 to 5.5 V
• Program/erase cycles: 1,000 times (program ROM 1, program ROM
2), or 10,000 times (data flash)
• Program security: ROM code protect, ID code check
On-chip debug, on-board flash rewrite, address match interrupt × 4
32 MHz/VCC1 = 2.7 to 5.5 V, VCC2 = 2.7 V to VCC1
27 mA (32 MHz/VCC1 = VCC2 = 3 V)
2.0 μA(VCC1 = VCC2 = 3 V (in stop mode)
-20°C to 85°C, -40°C to 85°C ⁽²⁾,
100-pin QFP: PRQP0100JD-B (Previous package code: 100P6F-A)
100-pin LQFP: PLQP0100KB-A (Previous package code: 100P6Q-A)
Notes:
1. IEBus is a registered trademark of NEC Electronics Corporation.
2. Refer to Table 1.2 “Specifications (2/2)” and Table 1.3 “Product List”regarding operating temperature.
REJ03B0277-0100 Rev.1.00 Jul.15, 2009
Page 3 of 90