SH72544R Datasheet, PDF (30/56 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 2 Software Specifications when Using the SH72546RFCC, SH72544R, SH72543R, SH72531FCC,
and SH72531
(2) Usage Example of Sequential Break Extension Setting
A tutorial program provided for the product is used as an example. For the tutorial program, refer
to section 6, Tutorial, in the SuperH^TM Family E10A-USB Emulator User’s Manual.
The conditions of Event Condition are set as follows:
1. Ch3
Breaks address H’00001088 when the condition [Only program fetched address after] is
satisfied.
2. Ch2
Breaks address H’000010B0 when the condition [Only program fetched address after] is
satisfied.
3. Ch1
Breaks address H’000010F2 when the condition [Only program fetched address after] is
satisfied.
Note: Do not set other channels.
4. Sets the content of the [Ch1,2,3] list box to [Break: Ch 3-2-1] in the [Combination action
(Sequential or PtoP)] dialog box.
5. Enables the condition of Event Condition 1 from the popup menu by clicking the right mouse
button on the [Event Condition] sheet.
Then, set the program counter and stack pointer (PC = H’00000800, R15 = H’FFF90000) in the
[Registers] window and click the [Go] button. If this does not execute normally, issue a reset and
execute the above procedures.
The program is executed up to the condition of Ch1 and halted. Here, the condition is satisfied in
the order of Ch3 -> 2 -> 1.
Rev. 2.00 Jun. 08, 2009 Page 24 of 46
REJ10J1941-0200