SH72544R Datasheet, PDF (10/56 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 1 Connecting the Emulator with the User System
1.3 Installing the H-UDI Port Connector on the User System
Table 1.3 shows the recommended H-UDI port connectors for the emulator.
Table 1.3 Recommended H-UDI Port Connectors
Connector
36-pin connector
14-pin connector
38-pin connector
Type Number
DX10M-36S
DX10M-36SE,
DX10G1M-36SE
2514-6002
2-5767004-2
Manufacturer
Hirose Electric Co., Ltd.
Minnesota Mining &
Manufacturing Ltd.
Tyco Electronics AMP K.K.
Specifications
Screw type
Lock-pin type
14-pin straight type
38-pin Mictor type
Note:
When designing the 36-pin connector layout on the user board, do not connect any
components under the H-UDI connector. When designing the 14-pin connector layout on
the user board, do not place any components within 3 mm of the H-UDI port connector.
When designing the 38-pin connector layout on the user board, reduce cross-talk noise etc.
by keeping other signal lines out of the region where the H-UDI port connector is situated.
As shown in figure 1.1, an upper limit (5 mm) applies to the heights of components
mounted around the user system connector.
Rev. 2.00 Jun. 08, 2009 Page 4 of 46
REJ10J1941-0200