PDI1394P23 Datasheet, PDF (39/42 Pages) NXP Semiconductors – 2-port/1-port 400 Mbps physical layer interface

Philips Semiconductors
2-port/1-port 400 Mbps physical layer interface
Preliminary data
PDI1394P23
19.0 POWER-CLASS PROGRAMMING
The PC0–PC2 terminals are programmed to set the default value of the power-class indicated in the pwr field (bits 21–23) of the transmitted
self-ID packet. Descriptions of the various power-classes are given in Table 21. The default power-class value is loaded following a hardware
reset, but is overridden by any value subsequently loaded into the Pwr_Class field in register 4.
Table 21. Power Class Descriptions
PC0–PC2
DESCRIPTION
000
Node does not need power and does not repeat power.
001
Node is self powered, and provides a minimum of 15 W to the bus.
010
Node is self powered, and provides a minimum of 30 W to the bus.
011
Node is self powered, and provides a minimum of 45 W to the bus.
100
Node may be powered from the bus and is using up to 3 W.
101
Node is powered from the bus and uses up to 3 W. No additional power is needed to enable the link.
110
Node is powered from the bus and uses up to 3 W. An additional 3 W is needed to enable the link.
111
Node is powered from the bus and uses up to 3 W. An additional 7 W is needed to enable the link.
2001 Sep 06
39