MN101E30N Datasheet, PDF (35/48 Pages) Panasonic Semiconductor – 8-bit Single-chip Microcontroller

MN101E30N/E30R/EF30R
8-bit Single-chip Microcontroller
PubNo. 2163001-019E
*8
Measured under condition without load. (pull-up / pull-down resistors are unconnected.)
• The supply current during operation, I_DD1 to I_DD4 are measured under the following
conditions:
After all I/O pins are set to input mode and the oscillation is set to <NORMAL mode>, the
MMOD pin is at V_SS level, the input pins are at V_DD5 level, and a 20 MHz square wave of
V_DD5 and V_SS amplitudes is input to the OSC1 pin.
• The supply current during operation, I_DD5 and I_DD6 are measured under the following conditions:
After all I/O pins are set to input mode and the oscillation is set to <SLOW mode>, the MMOD pin
is at V_SS level, the input pins are at V_DD5 level, and a 32.768 kHz square wave of V_DD5 and V_SS
amplitudes is input to the XI pin.
• The supply current during HALT1 mode, I_DD7 and I_DD8 are measured under the following
conditions:
After all I/O pins are set to input mode and the oscillation is set to <HALT1 mode>, the input pins
are at V_DD5 level, and an 32.768 kHz square wave of V_DD5 and V_SS amplitudes is input to the XI
pin.
• The supply current during STOP mode, I_DD9 and I_DD10 are measured under the following
conditions:
After the oscillation is set to <STOP mode>, the MMOD pin is at V_SS level, the input pins are at
V_DD5 level, and the OSC1 and XI pins are unconnected.
• The values in parentheses are for Flash version.
Publication date: October 2015