AR0130 Datasheet, PDF (53/53 Pages) ON Semiconductor – CMOS Digital Image Sensor

AR0130: 1/3-Inch CMOS Digital Image Sensor
Revision History
• Updated note 4 in Figure 2: “Typical Configuration: Parallel Pixel Data Interface,” on
page 7
• Added Figure 3: “48-Pin iLCC Pinout Diagram,” on page 9
• Updated “Parallel Output Data Timing” on page 14
• Updated Figure 12: “Timing Diagram,” on page 15
• Updated Table 4, “Frame Time (Example Based on 1280 x 960, 45 Frames Per
Second),” on page 15
• Updated Table 6, “Real-Time Context-Switchable Registers,” on page 17
• Updated “To Configure and Use the PLL:” on page 18
• Updated “To Enter Soft Standby:” on page 19
• Updated “Single Frame” on page 25
• Deleted “Temperature Sensor”
• Updated “Embedded Statistics” on page 27
• Updated “Column Correction Retriggering Due to Mode Change” on page 30
• Added Figure 28: “48 iLCC Package Outline Drawing,” on page 38
• Updated Figure 30: “Two-Wire Serial Bus Timing Parameters,” on page 40
• Updated Table 8, “Two-Wire Serial Bus Characteristics,” on page 41
• Updated note 1 in Table 18, “Standby Current Consumption ,” on page 47
• Updated “Power-Up Sequence” on page 48
• Updated Figure 33: “Power Up,” on page 48
• Updated Table 19, “Power-Up Sequence,” on page 49
• Updated “Power-Down Sequence” on page 50
• Updated Figure 34: “Power Down,” on page 50
• Updated Table 20, “Power-Down Sequence,” on page 50
Rev. A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/1/11
• Initial release
ON Semiconductor and the ON logo are registered trademarks of Semiconductor Components Industries, LLC (SCILLC) or its subsidiaries in the United States and/or other countries. SCILLC owns the
rights to a number of patents, trademarks, copyrights, trade secrets, and other intellectual property. A listing of SCILLC’s product/patent coverage may be accessed at www.onsemi.com/site/pdf/
Patent-Marking.pdf. SCILLC reserves the right to make changes without further notice to any products herein. SCILLC makes no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does SCILLC assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including
without limitation special, consequential or incidental damages. “Typical” parameters which may be provided in SCILLC data sheets and/or specifications can and do vary in different applications
and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. SCILLC does not convey
any license under its patent rights nor the rights of others. SCILLC products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body,
or other applications intended to support or sustain life, or for any other application in which the failure of the SCILLC product could create a situation where personal injury or death may occur.
Should Buyer purchase or use SCILLC products for any such unintended or unauthorized application, Buyer shall indemnify and hold SCILLC and its officers, employees, subsidiaries, affiliates, and
distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such
unintended or unauthorized use, even if such claim alleges that SCILLC was negligent regarding the design or manufacture of the part. SCILLC is an Equal Opportunity/Affirmative Action Employer.
This literature is subject to all applicable copyright laws and is not for resale in any manner.
AR0130 DS Rev. L Pub. 6/15 EN
53
©Semiconductor Components Industries, LLC, 2015 .