DS90C387R Datasheet, PDF (4/28 Pages) National Semiconductor (TI) – 85MHz Dual 12-Bit Double Pumped Input LDI Transmitter - VGA/UXGA

Electrical Characteristics (Continued)
Over recommended operating supply and temperature ranges unless otherwise specified.(Note 2)
Symbol
Parameter
Conditions
Min
Typ
TRANSMITTER SUPPLY CURRENT
ICCTW Transmitter Supply Current
R_L = 100Ω, C_L = 5 f = 32.5 MHz,
115
Worst Case
pF,
DUAL = V_CC
Worst Case
f = 32.5 MHz,
75
Pattern
DUAL = Gnd
(Figure 3
f = 65 MHz,
150
, BAL=High
DUAL = V_CC
(enabled), V_CC = _{f = 65 MHz,}
95
3.6V
DUAL = Gnd
f = 85 MHz,
175
DUAL = V_CC
f = 85 MHz,
110
DUAL = Gnd
ICCTG Transmitter Supply Current
R_L = 100Ω, C_L = 5 f = 32.5 MHz,
110
16 Grayscale Case
pF,
DUAL = V_CC
16 Grayscale
f = 32.5 MHz,
70
Pattern
DUAL = Gnd
Figure 2, BAL =
f = 65 MHz,
135
High (enabled),
DUAL = V_CC
V_CC = 3.6V
f = 65 MHz,
90
DUAL = Gnd
f = 85 MHz,
155
DUAL = V_CC
f = 85 MHz,
100
DUAL = Gnd
ICCTZ Transmitter Supply Current
PD = Low
4.8
Power Down
Driver Outputs in TRI-STATE under
Powerdown Mode
Max Units
180 mA
mA
215 mA
mA
235 mA
mA
170 mA
mA
205 mA
mA
225 mA
mA
85
µA
Note 1: “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. They are not meant to imply that the device
should be operated at these limits. The tables of “Electrical Characteristics” specify conditions for device operation.
Note 2: Typical values are given for V_CC = 3.3V and T _A = +25˚C. Device tested in Non-Balanced mode only.
Note 3: Current into device pins is defined as positive. Current out of device pins is defined as negative. Voltages are referenced to ground unless otherwise
specified (except V_OD and ∆V_OD).
Note 4: Low Swing DC threshold testing is preformed on data and control inputs only. Clock inputs tested by functional testing only.
DIGITAL DC CHARACTERISTICS for Two-Wire Serial Communication
Interface
Over recommended operating supply and temperature ranges unless otherwise specified.(Note 2) Parameters list below only
valid when I2CSEL pin = Vcc.
Symbol
Parameter
Conditions
Min
Typ
Max
Units
V_IN(1)
Logical “ 1 ” input voltage
2.1
V_IN(0)
Logical “ 0 ” input voltage
V_OL
Serial Bus Low level output
I_OL=3mA
voltage
V
0.8
V
0.4
V
I_OL=6mA
0.6
V
www.national.com
4