PIC16LF1847 Datasheet, PDF (352/408 Pages) Microchip Technology – 18/20/28-Pin Flash Microcontrollers with nanoWatt XLP Technology

PIC16(L)F1847
30.2 DC Characteristics: PIC16(L)F1847-I/E (Industrial, Extended) (Continued)
PIC16LF1847
PIC16F1847
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Param
No.
Device
Characteristics
Min. Typ† Max. Units
VDD
Conditions
Note
Supply Current (IDD)^{(1, 2)}
D020
—
2.0
3.1
mA
3.0 FOSC = 32 MHz
—
2.5
3.5
mA
3.6 ^{HS Oscillator mode (Note 4)}
D020
—
2.0
3.1
mA
3.0 FOSC = 32 MHz
—
2.5
3.5
mA
5.0 ^{HS Oscillator mode (Note 4)}
D021
—
300
—
A
1.8 FOSC = 4 MHz
—
500
—
A
3.0 ^{EXTRC mode (Note 5)}
D021
—
350
—
A
1.8 FOSC = 4 MHz
—
550
—
A
3.0 ^{EXTRC mode (Note 5)}
—
620
—
A
5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to VDD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
3: 8 MHz internal RC oscillator with 4x PLL enabled.
4: 8 MHz crystal oscillator with 4x PLL enabled.
5: For RC oscillator configurations, current through REXT is not included. The current through the resistor can be extended
by the formula IR = VDD/2REXT (mA) with REXT in k
DS41453A-page 354
Preliminary
 2011 Microchip Technology Inc.