PIC24HJ256GP210A-I Datasheet, PDF (265/326 Pages) Microchip Technology – 16-bit Microcontrollers with Advanced Analog

PIC24HJXXXGPX06A/X08A/X10A
FIGURE 24-12:
SPIx MASTER MODE (FULL-DUPLEX, CKE = 0, CKP = X, SMP = 1) TIMING
CHARACTERISTICS
SCKx
(CKP = 0)
SCKx
(CKP = 1)
SP10
SP35
SP21
SP20
SP20
SP21
SDOx
SDIx
MSb
SP30, SP31
MSb In
SP40 SP41
Bit 14 - - - - - -1
LSb
Bit 14 - - - -1
SP30, SP31
LSb In
Note: Refer to Figure 24-1 for load conditions.
TABLE 24-31: SPIx MASTER MODE (FULL-DUPLEX, CKE = 0, CKP = x, SMP = 1) TIMING
REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 2.4V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  TA  +125°C for Extended
Param
No.
Symbol
Characteristic⁽¹⁾
Min Typ⁽²⁾ Max Units
Conditions
SP10 TscP
Maximum SCK Frequency
—
—
10
MHz -40ºC to +125ºC and
see Note 3
SP20 TscF
SCKx Output Fall Time
—
—
—
ns See parameter DO32
and Note 4
SP21 TscR
SCKx Output Rise Time
—
—
—
ns See parameter DO31
and Note 4
SP30 TdoF
SDOx Data Output Fall Time
—
—
—
ns See parameter DO32
and Note 4
SP31 TdoR
SDOx Data Output Rise Time —
—
—
ns See parameter DO31
and Note 4
SP35 TscH2doV, SDOx Data Output Valid after —
6
20
ns
—
TscL2doV SCKx Edge
SP36 TdoV2scH, SDOx Data Output Setup to
30
—
—
ns
—
TdoV2scL First SCKx Edge
SP40 TdiV2scH, Setup Time of SDIx Data
30
—
—
ns
—
TdiV2scL Input to SCKx Edge
SP41 TscH2diL, Hold Time of SDIx Data Input 30
—
—
ns
—
TscL2diL to SCKx Edge
Note 1: These parameters are characterized, but are not tested in manufacturing.
2: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
3: The minimum clock period for SCKx is 100 ns. The clock generated in Master mode must not violate this
specification.
4: Assumes 50 pF load on all SPIx pins.
 2009-2012 Microchip Technology Inc.
DS70592D-page 265