PIC24HJ256GP210A-I Datasheet, PDF (246/326 Pages) Microchip Technology – 16-bit Microcontrollers with Advanced Analog

PIC24HJXXXGPX06A/X08A/X10A
TABLE 24-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  TA  +125°C for Extended
Parameter
No.⁽³⁾
Typical⁽²⁾
Max
Units
Conditions
Power-Down Current (IPD)⁽¹⁾
DC60d
50
200
A
-40°C
DC60a
DC60b
50
200
200
500
A
+25°C
3.3V Base Power-Down Current⁽³⁾
A
+85°C
DC60c
600
1000
A
+125°C
DC61d
8
13
A
-40°C
DC61a
DC61b
10
12
15
20
A
A
+25°C
+85°C
3.3V Watchdog Timer Current: IWDT⁽³⁾
DC61c
13
25
A
+125°C
Note 1: IPD (Sleep) current is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock active, OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration word
• All I/O pins are configured as inputs and pulled to VSS
• MCLR = VDD, WDT and FSCM are disabled, all peripheral modules except the ADC are disabled
(PMDx bits are all ‘1’s). The following ADC settings are enabled for each ADC module (ADCx) prior to
executing the PWRSAV instruction: ADON = 1, VCFG = 1, AD12B = 1 and ADxMD = 0.
• VREGS bit (RCON<8>) = 0 (i.e., core regulator is set to stand-by while the device is in Sleep mode)
• RTCC is disabled.
• JTAG is disabled
2: Data in the “Typ” column is at 3.3V, +25ºC unless otherwise stated.
3: The Watchdog Timer Current is the additional current consumed when the WDT module is enabled. This
current should be added to the base IPD current.
4: These currents are measured on the device containing the most memory in this family.
5: These parameters are characterized, but are not tested in manufacturing.
DS70592D-page 246
 2009-2012 Microchip Technology Inc.