PIC18F2X1X Datasheet, PDF (216/380 Pages) Microchip Technology – 28/40/44-PIN FLASH MICROCONTROLLERS WITH 10-BIT A/D AND NANO WATT TECHNOLOGY

PIC18F2X1X/4X1X
The analog reference voltage is software selectable
to either the device’s positive and negative supply
voltage (VDD and VSS), or the voltage level on the
RA3/AN3/VREF+ and RA2/AN2/VREF-/CVREF pins.
The A/D converter has a unique feature of being able
to operate while the device is in Sleep mode. To oper-
ate in Sleep, the A/D conversion clock must be derived
from the A/D’s internal RC oscillator.
The output of the sample and hold is the input into the
converter, which generates the result via successive
approximation.
FIGURE 18-1:
A/D BLOCK DIAGRAM
A device Reset forces all registers to their Reset state.
This forces the A/D module to be turned off and any
conversion in progress is aborted.
Each port pin associated with the A/D converter can
be configured as an analog input, or as a digital I/O.
The ADRESH and ADRESL registers contain the
result of the A/D conversion. When the A/D
conversion is complete, the result is loaded into the
ADRESH:ADRESL register pair, the GO/DONE bit
(ADCON0 register) is cleared and A/D Interrupt Flag
bit ADIF is set. The block diagram of the A/D module
is shown in Figure 18-1.
10-bit
Converter
A/D
Reference
Voltage
CHS3:CHS0
1100
1011
1010
1001
1000
0111
0110
0101
VAIN
(Input Voltage)
0100
0011
0010
VCFG1:VCFG0
VREF+
VREF-
VDD
X0
X1
1X
0X
VSS
0001
0000
Note 1: Channels AN5 through AN7 are not available on 28-pin devices.
2: I/O pins have diode protection to VDD and VSS.
AN12
AN11
AN10
AN9
AN8
AN7⁽¹⁾
AN6⁽¹⁾
AN5⁽¹⁾
AN4
AN3
AN2
AN1
AN0
DS39636A-page 214
Preliminary
 2004 Microchip Technology Inc.