PIC16F737-I Datasheet, PDF (163/276 Pages) Microchip Technology – 28/40/44-Pin, 8-Bit CMOS Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology

PIC16F7X7
13.0 COMPARATOR MODULE
The comparator module contains two analog com-
parators. The inputs to the comparators are
multiplexed with I/O port pins, RA0 through RA3, while
the outputs are multiplexed to pins RA4 and RA5. The
on-chip voltage reference (Section 14.0 “Comparator
Voltage Reference Module”) can also be an input to
the comparators.
The CMCON register (Register 13-1) controls the
comparator input and output multiplexers. A block
diagram of the various comparator configurations is
shown in Figure 13-1.
REGISTER 13-1:
CMCON: COMPARATOR MODULE CONTROL REGISTER (ADDRESS 9Ch)
R-0
R-0
R/W-0 R/W-0 R/W-0 R/W-1 R/W-1 R/W-1
C2OUT C1OUT C2INV C1INV
CIS
CM2
CM1
CM0
bit 7
bit 0
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2-0
C2OUT: Comparator 2 Output bit
When C2INV = 0:
1 = C2 VIN+ > C2 VIN-
0 = C2 VIN+ < C2 VIN-
When C2INV = 1:
1 = C2 VIN+ < C2 VIN-
0 = C2 VIN+ > C2 VIN-
C1OUT: Comparator 1 Output bit
When C1INV = 0:
1 = C1 VIN+ > C1 VIN-
0 = C1 VIN+ < C1 VIN-
When C1INV = 1:
1 = C1 VIN+ < C1 VIN-
0 = C1 VIN+ > C1 VIN-
C2INV: Comparator 2 Output Inversion bit
1 = C2 output inverted
0 = C2 output not inverted
C1INV: Comparator 1 Output Inversion bit
1 = C1 output inverted
0 = C1 output not inverted
CIS: Comparator Input Switch bit
When CM2:CM0 = 110:
1 = C1 VIN- connects to RA3/AN3
C2 VIN- connects to RA2/AN2
0 = C1 VIN- connects to RA0/AN0
C2 VIN- connects to RA1/AN1
CM2:CM0: Comparator Mode bits
Figure 13-1 shows the Comparator modes and CM2:CM0 bit settings.
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
 2004 Microchip Technology Inc.
DS30498C-page 161