IS66WVD1M16ALL Datasheet, PDF (7/52 Pages) Integrated Silicon Solution, Inc – Single device supports asynchronous and burst operation

IS66WVD1M16ALL
Functional Description
In general, this device is high-density alternatives to SRAM and Pseudo SRAM products popular
in low-power, portable applications.
The 16Mb device contains a 16,777,216-bit DRAM core organized as 1,048,576 addresses by
16 bits. This device implements a multiplexed address/data bus.
This multiplexed configuration supports greater bandwidth through a x16 data bus, yet still
reduces the required signal count.
The CellularRAM bus interface supports both asynchronous and burst mode transfers.
Power-Up Initialization
CellularRAM products include an on-chip voltage sensor used to launch the power-up initialization
process. Initialization will configure the BCR and the RCR with their default settings (see Table 3
and Table 8). VDD and VDDQ must be applied simultaneously.
When they reach a stable level at or above 1.7V, the device will require 150μs to complete
its self-initialization process. During the initialization period, CE# should remain HIGH. When
initialization is complete, the device is ready for normal operation.
Figure 1: Power-Up Initialization Timing
VDD=1.7V
VDD
VDDQ
tPU > 150us
Device Initialization
Device ready for
normal operation
Rev. A | July 2013
www.issi.com - [e-mail]
7