X40231 Datasheet, PDF (32/36 Pages) Intersil Corporation – Triple Voltage Monitors, POR, 2 kbit EEPROM MEMORY, and Single/Dual DCP

X40231, X40233, X40235, X40237, X40239
V_TRIPX (X = 1,2,3) PROGRAMMING PARAMETERS (See Figure 33)
Parameter
Description
t_VPS
t_VPH
t_TSU
t_THD
t_VPO
V_TRIPx Program Enable Voltage Setup time
V_TRIPx Program Enable Voltage Hold time
V_TRIPx Setup time
V_TRIPx Hold (stable) time
V_TRIPx Program Enable Voltage Off time
(Between successive adjustments)
t_WC
V_TRIPx Write Cycle time
V_P
Programming Voltage
V_ta
V_TRIPx Program Voltage accuracy
Programmed at 25°C.)
V_tv
V_TRIP Program variation after programming (-40 - 85°C).
(Programmed at 25°C.)
Notes: 100% tested.
Min
10
10
10
10
1
10
-100
-25
Typ Max
5
10
15
+100
+10 +25
Units
µs
µs
µs
µs
ms
ms
V
mV
mV
RESET, V2FAIL, V3FAIL OUTPUT TIMING. (See Figure 30, Figure 31, Figure 32)
Symbol
Description
t_PURST
t_MRD(31)(2)
t_MRDPW
t_RPDx
t_Fx
t_Rx
V_RVALID
Power-on Reset delay time
MR to RESET propagation delay
MR pulse width
V_CC, V2MON, V3MON to RESET,
V2FAIL, V3FAIL propagation
delay (respectively)
V_CC, V2MON, V3MON Fall Time
V_CC, V2MON, V3MON Rise Time
V_CC for RESET, V2FAIL, V3FAIL
Valid⁽³⁾.
Condition
PUP1 = 0, PUP0 = 0
PUP1 = 0, PUP0 = 1
PUP1 = 1, PUP0 = 0
PUP1 = 1, PUP0 = 1
See ^(1)(2)(4)
See ⁽⁵⁾
Min.
25
50
100
150
500
20
20
1
Typ.
50
100
200
300
Max.
75
150
300
450
5
Units
ms
ms
ms
ms
µs
ns
20
µs
mV/µs
mV/µs
V
Notes: 1. See Figure 31 for timing diagram.
Notes: 2. See Figure 25 for equivalent load.
Notes: 3. This parameter describes the lowest possible V_CC level for which the outputs RESET, V2FAIL, and V3FAIL will be correct with respect to
their inputs (V_CC, V2MON, V3MON).
Notes: 4. From MR rising edge crossing V_IH, to RESET rising edge crossing V_OH.
Notes: 5. Equivalent input circuit for V_XMON
V_XMON
+
V_REF
–
OUTPUT
t_RPDX = 20µs worst case
32
FN8115.0
April 11, 2005