TLE9260-3QX Datasheet, PDF (55/175 Pages) Infineon Technologies AG – Dedicated Data Sheets are available for the different product variants

TLE9260-3QX
5.4.9 Electrical Characteristics
Table 15 Electrical Characteristics
V_S = 5.5 V to 28 V; T_j = -40 °C to +150 °C; 4.75 V < VCAN < 5.25 V; RL = 60Ω; CAN Normal Mode; all voltages
with respect to ground, positive current flowing into pin
(unless otherwise specified)
Parameter
Symbol
Min.
Values
Unit Note /
Number
Typ. Max.
Test Condition
CAN Partial Network Timing
Timeout for bus inactivity
t_SILENCE
0.6
–
Bias reaction time
t_bias
–
–
Wake-up reaction time
(WUP or WUF)
t_{WU_WUP/WUF} –
–
Min. Bit Time
t_{Bit_min}
1
–
1.2
s
1)
P_5.4.1
200
µs
1)_{Load RL = 60 Ω, P_5.4.2}
C_L = 100 pF,
C_GND = 100 p
100
µs
1)2)3) _Wake-up
P_5.4.3
reaction time after
a valid WUP or
WUF;
–
µs
1)4)
P_5.4.4
1) Not subject to production test, tolerance defined by internal oscillator tolerance
2) Wake-up is signalized via INT pin activation in SBC Stop Mode and via VCC1 ramping up with wake from SBC Sleep Mode;
3) For WUP: time starts with end of last dominant phase of WUP; for WUF: time starts with end of CRC delimiter of the WUF
4) The minimum bit time corresponds to a maximum bit rate of 1 Mbit/s. The lower end of the bit rate depends on the protocol
IC or the permanent dominant detection circuitry preventing a permanently dominant clamped bus.
Data Sheet
55
Rev. 1.1, 2014-09-26