TLE9260-3QX Datasheet, PDF (25/175 Pages) Infineon Technologies AG – Dedicated Data Sheets are available for the different product variants

TLE9260-3QX
System Features
5.1.1.2 SBC Init Mode
In SBC Init Mode, the device waits for the microcontroller to finish its startup and initialization sequence. In the
SBC Init Mode any valid SPI command will bring the SBC to SBC Normal Mode. During the long open window the
watchdog has to be triggered. Thereby the watchdog will be automatically configured.
A missing watchdog trigger during the long open window will cause a watchdog failure and the device will enter
SBC Restart Mode.
Wake events are ignored during SBC Init Mode and will therefore be lost.
Note: Any SPI command will bring the SBC to SBC Normal Mode even if it is a illegal SPI command (see
Chapter 14.2).
Note: For a safe start-up, it is recommended to use the first SPI command to trigger and to configure the watchdog
(see Chapter 13.2).
Note: At power up no VCC1_UV will be issued nor will FOx be triggered as long as VCC1 is below the V_RT,x
threshold and if VS is below the VCC1 short circuit detection threshold V_S,UV. The RO pin will be kept low as
long as VCC1 is below the selected V_RT,x threshold.
Data Sheet
25
Rev. 1.1, 2014-09-26