TLE75080-EMH Datasheet, PDF (45/80 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

7.6
Electrical Characteristics Power Stages
TLE75080-EMH
Power Stages
Table 10 Electrical Characteristics: Power Stage
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Number
Output Characteristics
On-State Resistance
On-State Resistance
R_DS(ON)
–
R_DS(ON)
–
Nominal load current
(all channels active)
I_L(NOM)
–
Nominal load current
(all channels active)
I_L(NOM)
–
Nominal load current
I_L(NOM)
–
(half of channels active)
Load current for maximum I_L(EAR)
–
energy dissipation - repetitive
(all channels active)
Inverse current capability per -I_L(IC)
–
channel
1.0
–
Ω
1)
P_7.6.1
T_J = 25 °C
1.8
2.2
Ω
T_J = 150 °C
I_L = I_L(EAR) =
220 mA
P_7.6.2
330
500²⁾³⁾ mA ¹⁾
P_7.6.3
T_A = 85 °C
T_J ≤ 150 °C
260
500²⁾³⁾ mA ¹⁾
T_A = 105 °C
T_J ≤ 150 °C
470
500²⁾³⁾ mA ¹⁾
P_7.6.4
P_7.6.5
220 –
T_A = 85 °C
T_J ≤ 150 °C
mA ¹⁾
P_7.6.8
T_A = 85 °C
T_J ≤ 150 °C
–
I_L(EAR) mA
1)
P_7.6.9
No influences on
switching
functionality of
unaffected
channels -
parameter
deviations possible
Maximum energy dissipation E_AR
repetitive pulses - 2*I_L(EAR)
(two channels in parallel)
–
–
15
mJ
1)
P_7.6.11
T_J(0) = 85 °C
I_L(0) = 2*I_L(EAR)
2*10⁶ cycles
HWCR.PAR = “1” for
affected channels
Power stage voltage drop at V_DS(OP)
–
–
1
V
R_L = 50 Ω
P_7.6.15
low battery
V_S = V_S(OP),max
V_S1 = V_S(OP),max
V_S2 = V_S(OP),max
refer to Figure 16
Drain to Source Output
clamping voltage
V_DS(CL)
42
46
55
V
I_L = 20 mA
P_7.6.16
V_S = V_Sn= 36 V
Data Sheet
45
Rev. 1.0, 2016-06-22