TLE75080-EMH Datasheet, PDF (37/80 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75080-EMH
Power Supply
Table 8 Electrical Characteristics Power Supply (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Idle to Sleep delay
t_IDLE2SLEEP –
100
200
µs
1)
P_6.3.54
from IDLE pin to
Standard Diagnosis
= 0000_H (see
Chapter 10.5 for
details)
external pull-down
SO to GND
required
Idle to Active delay
t_IDLE2ACTIVE –
Active to Idle delay
t_ACTIVE2IDLE –
Sleep to Limp Home delay t_SLEEP2LH –
Limp Home to Sleep delay t_LH2SLEEP –
100 200 µs
100 200 µs
300 600 µs
+t_ON +t_ON
200 400 µs
+t_OFF +t_OFF
1)
P_6.3.55
from INn or CSN
pins to MODE = 10_B
1)
P_6.3.56
from INn or CSN
pins to MODE = 11_B
1)
P_6.3.57
from INn pins
to V_DS = 10% V_S
1)
P_6.3.58
from INn pins to
Standard Diagnosis
= 0000_H (see
Chapter 10.6.1 for
details). External
pull-down SO to
GND required
Limp Home to Active delay t_LH2ACTIVE –
50
100
µs
1)
P_6.3.59
from IDLE pin to
MODE = 10_B
Data Sheet
37
Rev. 1.0, 2016-06-22