TLE75080-EMH Datasheet, PDF (33/80 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75080-EMH
Power Supply
Table 8 Electrical Characteristics Power Supply (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Analog supply current
I_VS(IDLE)
–
–
0.3 mA IDLE = “high”
P_6.3.7
consumption in Idle mode
V_INn floating
with loads (COR)
f_SCLK = 0 MHz
HWCR.ACT = 0_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
V_S ≤ V_DD - 1 V
Analog supply current
I_VS(ACTIVE)
–
–
7.7 mA IDLE = “high”
P_6.3.10
consumption in Active mode
V_INn floating
with loads - channels OFF
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
Analog supply current
I_VS(ACTIVE)
–
–
5.0 mA IDLE = “high”
P_6.3.14
consumption in Active mode
V_INn floating
with loads - channels OFF
f_SCLK = 0 MHz
(COR)
HWCR.ACT = 1_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
V_S ≤ V_DD - 1 V
Analog supply current
I_VS(ACTIVE)
–
–
8.7 mA IDLE = “high”
P_6.3.18
consumption in Active mode
V_INn floating
with loads - channels ON
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 1_B
DIAG_IOL.OUTn =
0_B
DIAG_OLONEN.MU
X = 0100_B
V_CSN = V_DD
Data Sheet
33
Rev. 1.0, 2016-06-22