TLE75080-EMH Datasheet, PDF (11/80 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75080-EMH
Block Diagram and Terms
2.2
Terms
Figure 2 shows all terms used in this data sheet, with associated convention for positive values.
V_S
VD D
VID LE
V IN0
VIN1
IVDD
I_{ID L E}
I IN0
I IN1
VDD
IDLE
IN0
IN1
ICSN
VCSN
ISCLK
V _SCLK
ISI
VSI
ISO
VSO
CSN
SCLK
SI
SO
IVS
VS
IV S1
VS1
IL_S0
OUT0_HS
IL_S2
OUT2_HS
IL_S4
OUT4_HS
I_{L_S6}
OUT6_HS
VDS6 V DS4 VDS 2 VDS0 V S1
VOUT0
V OUT2
VOUT4
VOUT6
VS2
GND
OUT1_HS
OUT3_HS
OUT5_HS
OUT7_HS
IGND
IVS 2
IL_S1
VDS7 VDS 5 VDS3 V DS1 VS 2
IL_S3
VOU T1
IL_S5
V_OUT3
IL_S7
V OUT5
VOU T7
Terms_8HS.emf
Figure 2 Voltage and Current definition
In all tables of electrical characteristics the channel related symbols without channel numbers are valid for each
channel separately (e.g. V_DS specification is valid for V_DS0 ... V_DS7).
Furthermore, parameters relative to output current can be indicated without specifying whether the current is going
into the Drain pin or going out of the Source pin, unless otherwise specified. For instance, nominal output current
can be indicated in the following ways: I_L(NOM) I_{L_HS(NOM)} I_{L_S(NOM)}
All SPI registers bits are marked as follows: ADDR.PARAMETER (e.g. HWCR.RST) with the exception of the bits in
the Diagnosis frames which are marked only with PARAMETER (e.g. UVRVS).
Data Sheet
11
Rev. 1.0, 2016-06-22