TLE75080-EMH Datasheet, PDF (17/80 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75080-EMH
General Product Characteristics
Table 2 Absolute Maximum Ratings (cont’d)¹⁾
T_J = -40 °C to +150 °C
all voltages with respect to ground, positive current flowing into pin (unless otherwise specified)
Voltage ranges specifed for V_S apply also to V_S1 and V_S2 (unless otherwise specified)
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Number
ESD Susceptibility CDM
Pin 1, 12, 13, 24 (corner pins)
V_ESD
-750 – 750
V
6)
CDM
P_4.1.52
ESD Susceptibility CDM
V_ESD
-500 – 500
V
6)
CDM
P_4.1.54
1) Not subject to production test, specified by design.
2) For a duration of t_on = 400 ms; t_on/t_off = 10%; limited to 100 pulses
3) Device is mounted on a FR4 2s2p board according to Jedec JESD51-2,-5,-7 at natural convection; the Product
(Chip+Package) was simulated on a 76.2 *114.3 *1.5 mm board with 2 inner copper layers (2 * 70 µm Cu, 2 * 35 µm Cu).
Where applicable a thermal via array under the exposed pad contacted the first inner copper layer.
4) Pulse shape represents inductive switch off: I_L(t) = I_L(0) x (1 - t / t_pulse); 0 < t < t_pulse
5) ESD susceptibility, HBM according to ANSI/ESDA/JEDEC JS001 (1.5k Ω, 100 pF)
6) ESD susceptibility, Charged Device Model “CDM” ESDA STM5.3.1 or ANSI/ESD S.5.3.1
Notes
1. Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
2. Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are not
designed for continuous repetitive operation.
4.2
Functional Range
Table 3 Functional range
Parameter
Symbol
Min.
Supply Voltage Range for
V_S(NOR)
7
Normal Operation
Upper Supply Voltage Range V_S(EXT,UP) 18
for Extended Operation
Lower Supply Voltage Range V_S(EXT,LOW) 3
for Extended Operation
Junction Temperature
T_J
-40
Logic supply voltage
V_DD
3
Values
Typ. Max.
–
18
–
28
–
7
–
150
–
5.5
Unit Note /
Test Condition
V
–
Number
P_4.2.1
V
Parameter deviation P_4.2.2
possible
V
Parameter deviation P_4.2.3
possible
°C –
P_4.2.4
V
–
P_4.2.5
Note: Within the functional or operating range, the IC operates as described in the circuit description. The electrical
characteristics are specified within the conditions given in the Electrical Characteristics table.
Data Sheet
17
Rev. 1.0, 2016-06-22