TLE75080-EMH Datasheet, PDF (36/80 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75080-EMH
Power Supply
Table 8 Electrical Characteristics Power Supply (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Overall current consumption I_SLEEP
–
in Sleep mode
I I _VS(SLEEP) + _VDD(SLEEP)
Overall current consumption I_IDLE
–
in Idle mode
I_VS(IDLE) + I_VDD(IDLE)
Overall current consumption I_ACTIVE
–
in Active mode - channels
OFF
I I _VS(ACTIVE) + _VDD(ACTIVE)
Overall current consumption I_ACTIVE
–
in Active mode - channels ON
I I _VS(ACTIVE) + _VDD(ACTIVE)
Voltage difference between V_SDIFF
–
V_S and V_DD supply lines
Timings
–
30
–
2.5
–
8
–
9
200 –
µA V_IDLE floating
V_INn floating
V_CSN = V_DD
T_J = 150 °C
P_6.3.41
mA IDLE = “high”
P_6.3.42
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 0_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
mA IDLE = “high”
P_6.3.45
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
mA IDLE = “high”
P_6.3.62
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 1_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
mV ¹⁾
P_6.3.52
Sleep to Idle delay
t_SLEEP2IDLE –
200
400
µs
1)
P_6.3.53
from IDLE pin to
TER + INST register
= 8680_H (see
Chapter 10.6.1 for
details)
Data Sheet
36
Rev. 1.0, 2016-06-22