TLE75008-EMD_15 Datasheet, PDF (42/64 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

8.6
Electrical Characteristics Protection
TLE75008-EMD
Protection Functions
Table 10 Electrical Characteristics Protection
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Over Load
Over Load detection current I_L(OVL0)
Over Load detection current I_L(OVL0)
Over Load detection current
Over Load detection current
Over Load detection current
I_L(OVL0)
I_L(OVL1)
I_L(OVL1)
Over Load detection current
Over Load threshold switch
delay time
I_L(OVL1)
t_OVLIN
1.3
1.7
2.3
A
1.25 1.55 2.3 A
1
1.45 2
A
0.7 0.95 1.3 A
0.65 0.85 1.3 A
0.5
0.8
1.25 A
110 170 260 µs
T_J = -40 °C
1)
T_J = 25 °C
T_J = 150 °C
T_J = -40 °C
1)
T_J = 25 °C
T_J = 150 °C
1)
Over Load shut-down delay t_OFF(OVL)
4
7
11
µs
1)
time
Over Temperature and Over Voltage
Thermal shut-down
temperature
T_J(SC)
150
175¹⁾ 220¹⁾ °C
Over voltage protection
V_S(AZ)
42
50
60
V
I_VS = 10 mA
Sleep mode
Reverse Polarity
Drain Source diode during V_DS(REV)
–
reverse polarity
800 –
mV ¹⁾
I_L = -10 mA
T_J = 25 °C
Sleep mode
Drain Source diode during V_DS(REV)
–
reverse polarity
650 –
mV I_L = -10 mA
T_J = 150 °C
Sleep mode
Timings
Restart time in Limp Home t_RETRY0(LH) 7
mode
10
13
ms
1)
Restart time in Limp Home t_RETRY1(LH) 14
20
26
ms
1)
mode
Restart time in Limp Home t_RETRY2(LH) 28
40
52
ms
1)
mode
Restart time in Limp Home t_RETRY3(LH) 56
80
104
ms
1)
mode
1) Not subject to production test - specified by design
Number
P_8.8.19
P_8.8.20
P_8.8.21
P_8.8.22
P_8.8.23
P_8.8.24
P_8.8.5
P_8.8.26
P_8.8.7
P_8.8.8
P_8.8.9
P_8.8.10
P_8.8.13
P_8.8.14
P_8.8.15
P_8.8.16
Data Sheet
42
Rev. 1.1, 2015-09-25