TLE75008-EMD_15 Datasheet, PDF (30/64 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

6.3
Electrical Characteristics Power Supply
TLE75008-EMD
Power Supply
Table 8 Electrical Characteristics Power Supply
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
VS pin
Analog supply undervoltage V_S(UV)
shutdown
1.5 –
Analog supply minimum
V_S(OP)
–
–
operative voltage
Undervoltage shutdown
V_S(HYS)
–
1
hysteresis
3.0
V
OUTn = ON
P_6.3.1
from V_DS ≤ 1 V
to UVRVS = 1_B
R_L = 50 Ω
4.0
V
OUT.OUTn = 1_B P_6.3.2
from UVRVS = 1_B
to V_DS ≤ 1 V
R_L = 50 Ω
–
V
1)
P_6.3.3
Analog supply current
I_VS(SLEEP)
–
consumption in Sleep mode
with loads
0.1
3
Analog supply current
I_VS(SLEEP)
–
consumption in Sleep mode
with loads
0.1
–
µA
1)
V_IDLE floating
V_INn floating
V_CSN = V_DD
T_J ≤ 85 °C
µA
1)
V_IDLE floating
V_INn floating
V_CSN = V_DD
T_J ≤ 85 °C
VS = 13.5 V
P_6.3.4
P_6.3.63
Analog supply current
I_VS(SLEEP)
–
consumption in Sleep mode
with loads
Analog supply current
I_VS(IDLE)
–
consumption in Idle mode
with loads
0.1
20
µA V_IDLE floating
V_INn floating
V_CSN = V_DD
T_J = 150 °C
P_6.3.5
–
2.2 mA IDLE = “high”
P_6.3.6
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 0_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
Data Sheet
30
Rev. 1.1, 2015-09-25