TLE75008-EMD_15 Datasheet, PDF (32/64 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75008-EMD
Power Supply
Table 8 Electrical Characteristics Power Supply (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
VDD pin
Logic Supply Operating
voltage
V_DD(OP)
3.0 –
5.5
V
f_SCLK = 5 MHz
P_6.3.23
Logic Supply Lower
Operating Voltage
V_DD(LOP)
3.0
–
4.5 V
–
P_6.3.24
Undervoltage shutdown
V_DD(UV)
1
–
3.0
V
V_SI = 0 V
P_6.3.25
V_SCLK = 0 V
V_CSN = 0 V
SO from “low” to
high impedance
Logic supply current in Sleep I_VDD(SLEEP) –
mode
Logic supply current in Sleep I_VDD(SLEEP) –
mode
Logic supply current in Idle I_VDD(IDLE) –
mode
Logic supply current in Idle I_VDD(IDLE) –
mode (COR)
Logic supply current in Active I_VDD(ACTIVE) –
mode - channels OFF
0.1
2.5
µA
1)
P_6.3.26
V_IDLE floating
V_INn floating
V_CSN = V_DD
T_J ≤ 85 °C
–
10
µA V_IDLE floating
V_INn floating
V_CSN = V_DD
T_J = 150 °C
P_6.3.27
–
0.3 mA IDLE = “high”
P_6.3.28
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 0_B
OUT.OUTn = 0_B
V_CSN = V_DD
–
2.2 mA IDLE = “high”
P_6.3.29
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 0_B
OUT.OUTn = 0_B
V_CSN = V_DD
V_S ≤ V_DD - 1 V
–
0.3 mA IDLE = “high”
P_6.3.30
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 0_B
V_CSN = V_DD
Data Sheet
32
Rev. 1.1, 2015-09-25