TLE75008-EMD_15 Datasheet, PDF (39/64 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75008-EMD
Power Stages
Table 9 Electrical Characteristics: Power Stage (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Number
Output leakage current
I_L(OFF)
–
0.1
5
µA
1)
P_7.6.20
(each channel)
V_IN = 0 V or floating
T_J = 150 °C
V_DS = 28 V
(Low-Side channels)
OUT.OUTn = 0
T_J = 150 °C
Timings
Turn-ON delay
t_DELAY(ON)
1
4
8
µs R_L = 50 Ω
P_7.6.21
(from INn pin or bit to V_OUT =
V_S = 13.5 V
90% V_S)
Active mode or
Limp Home mode
Turn-OFF delay
t_DELAY(OFF) 1
6
12
µs R_L = 50 Ω
P_7.6.22
(from INn pin or bit to V_OUT =
V_S = 13.5 V
10% V_S)
Active mode or
Limp Home mode
Turn-ON time
t_ON
(from INn pin or bit to V_OUT =
10% V_S)
6
15
35
µs R_L = 50 Ω
P_7.6.23
V_S = 13.5 V
Active mode or
Limp Home mode
Turn-OFF time
t_OFF
(from INn pin or bit to V_OUT =
90% V_S)
6
15
35
µs R_L = 50 Ω
P_7.6.24
V_S = 13.5 V
Active mode or
Limp Home mode
Turn-ON/OFF matching
t_ON - t_OFF -10
0
10
µs R_L = 50 Ω
P_7.6.25
V_S = 13.5 V
Active mode or
Limp Home mode
Turn-ON slew rate
V_DS = 70% to 30% V_S
dV/dt_ON
0.7
1.3
1.9
V/µs R_L = 50 Ω
P_7.6.26
V_S = 13.5 V
Active mode or
Limp Home mode
Turn-OFF slew rate
V_DS = 30% to 70% V_S
-dV/dt_OFF 0.7
1.3
1.9
V/µs R_L = 50 Ω
P_7.6.27
V_S = 13.5 V
Active mode or
Limp Home mode
Internal reference frequency t_SYNC
synchronization time
–
5
10
µs
1)
P_7.6.45
1) Not subject to production test - specified by design
2) If one channel has I_L(NOM),max applied, the remaining channels must be underloaded accordingly so that T_J < 150°C
3) I_L(NOM),max can reach I_L(OVL1),min
Data Sheet
39
Rev. 1.1, 2015-09-25